Page 1 of 1
Beta 1.3 forgets last directory
Posted: Tue Oct 07, 2003 10:03 pm
by heechee
(On 98 and XP) - v3.0 ß 1.3 doesn't remember the path where you last loaded a D64.
After startup device 8 always shows "Path:" (yup, empty)
Selecting ".." doesn't change anything, you must select a volume and navigate to your .d64 directory after every restart.
(No, c64.cfg is not read-only here
)
Posted: Wed Oct 08, 2003 9:35 am
by Stuart Toomer
Confirmed. When starting CCS64 a-fresh, CCS64 is not remember to set the Disk/Tape directory initially to the $LOADPATH setting in the C64.CFG file.
Posted: Wed Oct 08, 2003 9:47 am
by Stuart Toomer
Stuart Toomer wrote:Confirmed. When starting CCS64 a-fresh, CCS64 is not remember to set the Disk/Tape directory initially to the $LOADPATH setting in the C64.CFG file.
Erm, I tried again, and CCS64 'remembered' the load-directory. I cannot be sure that this is a genuine bug or a spurious fault. (Windows ME)
Posted: Wed Oct 08, 2003 12:46 pm
by heechee
Ah, when I select a D64 file ccs64 remembers the directory (selecting a D64 is enough, no need to run anything) but when I only start a .prg file and then quit the emulator the loadpath is not updated. There you go.
Posted: Wed Oct 08, 2003 2:35 pm
by Stuart Toomer
heechee wrote:Ah, when I select a D64 file ccs64 remembers the directory (selecting a D64 is enough, no need to run anything) but when I only start a .prg file and then quit the emulator the loadpath is not updated. There you go.
CCS64 updates the $LOADPATH setting for D64/G64/T64 files, but not for TAP/PRG/P00 files.
Posted: Mon Oct 13, 2003 1:30 am
by StevenRoy
The question now is: Is that a bug or is it a feature?
Posted: Mon Oct 13, 2003 8:16 am
by Stuart Toomer
StevenRoy wrote:The question now is: Is that a bug or is it a feature?
I think it's probably an over-sight. So, I have classified it as a bug in the CCS64 KB.