CCS64 Forum

Hello, I am new on this forum. I hope to learn much from here

I today installed CCS64 and I try to get the machine code monitor running.
I type in some 6510 hex code and try to run that, but apart from some trace-commands I see no way do do a go ( often the G command in the real monitor ).
Also in the downloaded manual the go-command is missing. I also tried to run my code using the sys-command from within Basic, but that does not work either.

Please can somebody help me out?

The HTML instructions that come with CCS64 describe all of the available commands.

Stuart Toomer wrote:The HTML instructions that come with CCS64 describe all of the available commands.

But no command to start the code, usually with 'G' <address>

I'm not an expert on the CCS64 MC Monitor, but would you not re-set the Program Counter (PC) address, then exit the Monitor?

Stuart Toomer wrote:I'm not an expert on the CCS64 MC Monitor, but would you not re-set the Program Counter (PC) address, then exit the Monitor?

No, every monitor program has a go-functie.
My purpose is to write some proggies from within the monitor and run them without intervention from Basic.
I already found another C64 emulator and that one has a go-command, as it shoud be.