CCS64 Forum

Elevator Action does not start a game. CCS64 3.7 loads up to title screen but game never starts. Tried with Kernal Version 3, KERNAL.ROM & JiffyDOS 6.1 C1541.ROM. Also tried with the kernal rom and 1541 drive controller bundled with WinVICE 2.0. Same results.

Same image/game runs fine under WinVICE 2.0.

Crossbow does not work. Image starts to load and at the Commodore 64 Basic Screen, the command Run is automatically typed, but the emulator proceeds no further. As with Elevator Action, I tried with Kernal Version 3, KERNAL.ROM & JiffyDOS 6.1 C1541.ROM. Also tried with the kernal rom and 1541 drive controller bundled with WinVICE 2.0. Same results occurred.

The same image/game runs fine under WinVICE 2.0.

-Trebor

Trebor wrote:Elevator Action does not start a game. CCS64 3.7 loads up to title screen but game never starts. Tried with Kernal Version 3, KERNAL.ROM & JiffyDOS 6.1 C1541.ROM. Also tried with the kernal rom and 1541 drive controller bundled with WinVICE 2.0. Same results.

Same image/game runs fine under WinVICE 2.0.

Crossbow does not work. Image starts to load and at the Commodore 64 Basic Screen, the command Run is automatically typed, but the emulator proceeds no further. As with Elevator Action, I tried with Kernal Version 3, KERNAL.ROM & JiffyDOS 6.1 C1541.ROM. Also tried with the kernal rom and 1541 drive controller bundled with WinVICE 2.0. Same results occurred.

The same image/game runs fine under WinVICE 2.0.

-Trebor

Hi Trebor! Here we go:

1. Elevator Action - Bug confirmed. I am using the Wanderer (WDR) release. Are you using another image of this game? It must be something strange that is specific to this game.

2. Crossbow (game) - I think this is a bad crack. I use the SGC version, which seems to work fine (I also have Maximum 1541 Speed set to ON). You can download it here:
http://noname.c64.org/csdb/release/?id=44487

Hi. Hakain informs me the bug concerning Elevator Action, a bug with the sprite-to-sprite collision-detection, will be fixed in CCS64 V3.8.