CCS64 Forum
http://www.ccs64.com/forum/

Direct3D Init FAILED - GetBackBuffer
http://www.ccs64.com/forum/viewtopic.php?f=1&t=255
Page 1 of 1

Author:  kamelito [ Fri Oct 01, 2004 9:23 pm ]
Post subject:  Direct3D Init FAILED - GetBackBuffer

Hi,

1) set the refresh rate to custom
2) set the refresh rate to 50hz

Result: Direct3D Init FAILED - GetBackBuffer

Rem if I click ok, CCS 3.0 beta 1.4 will be flashy and I'll need 4/5 ctrl+alt+suppr to kill it. (under windows xp)

kml

Author:  kamelito [ Fri Oct 01, 2004 10:05 pm ]
Post subject:  Re: Direct3D Init FAILED - GetBackBuffer

Hi again,

One thing I must add is that if I test the screen it works.
It only display the error when I apply the settings below.
Regards
kml


kamelito wrote:
Hi,

1) set the refresh rate to custom
2) set the refresh rate to 50hz

Result: Direct3D Init FAILED - GetBackBuffer

Rem if I click ok, CCS 3.0 beta 1.4 will be flashy and I'll need 4/5 ctrl+alt+suppr to kill it. (under windows xp)

kml

Author:  Stuart Toomer [ Sat Oct 02, 2004 12:53 am ]
Post subject: 

This is probably because your graphics card/driver doesn't support this.

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/